Profiling controls are not shown after the profiling is started

Symptom

After you start a profiling session, dotMemory shows the message "The profiler is running. Waiting for connection from the profiling process." but profiling controls are not loaded.

Possible reasons

• Firewall software prohibits TCP connection to localhost.

Solution

 Allow connections to localhost from any port in your firewall software.

• The application you are trying to profile is not a .NET application.

Solution

1. Check whether you chose the right profiling target. It is possible that a wrong executable file was specified in profiling options or a wrong process was selected for attaching.

2. Make sure the profiled application is a .NET application.
The more complex profiling scenario is when you are going to profile a .NET process that is run by a non-.NET process. In such a case, enable the Profile child process checkbox in Profiler Configuration and restart profiling.

3. If the previous steps don’t help, try to profile your application as a .NET Process. To run a profiling session, select Profile | .NET Process in the dotMemory Home page.